Syntax
>>>> FACTOR: factor
Parent Command
all third-level commands in block > OBSERVATION
Subcommand
-
Description
This command provides a conversion factor with which the data are multiplied so they comply with standard TOUGH2 units. The conversion factor is also applied to the standard deviation (see command >>>> DEVIATION (o)), i.e., the measurement error must be given in the same units as the data. The standard TOUGH2 units are used throughout the iTOUGH2 output file, i.e., all observed and calculated values as well as residuals and standard deviations have been multiplied by factor.
Example
> OBSERVATION
>> PRESSURE
>>> ELEMENT: WEL99
>>>> conversion FACTOR: 1E5 [bar] - [Pa]
>>>> pressure DATA in HOURS and bar on FILE: pres.dat
>>>> standard DEVIATION: 0.01 [bar]
<<<<
<<<
<<
See Also
>> SCALING