Manual Page for Command >> SCALING


Syntax
>> SCALING

Parent Command
> PARAMETER

 

Subcommand
>>> NONE
>>> SET

 

Description
This command selects as a parameter a constant factor with which the calculated TOUGH2 output will be multiplied. The factor is applied to the output that refers to a specific data set:

z = zTOUGH2 * factorwhere factor is the scaling factor and zTOUGH2 is the TOUGH2 output. The result z is compared to the measurement z* of the corresponding data set. This option allows correcting for a systematic, but unknown relative error in the data. The data set is identified by number using command >>> SET (p). If the factor is known and does not need to be estimated, use command >>>> FACTOR (o).

Example
> PARAMETER
>> SCALING factor
>>> SET No. : 1
>>>> ANNOTATION: correct amplitude
>>>> GUESS: 1.0
<<<<
<<<
<<

 

See Also
>> DRIFT | >> LAG | >> SHIFT | >>> SET (p) | >>>> FACTOR (o)